Installation Instructions
CVA 4070 en-CA
Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.
Installation
Installation options
The coffee system is designed to be built into cabinetry.
A combination with other Miele built in appliances is possible. If the machine is installed
in combination with other appliances, it should be installed with a protective base
between the appliance and the unit (exception: installation with a built-in plate warmer).
A special display cabinet is also available from your dealer or Miele, as an installation option.
Miele appliances can be installed ꢀush or proud. Discuss your installation
requirements with your architect, designer and installer.
58
Installation
Installation
^ If your cabinet has 3/4" (19 mm) side
walls, drill four holes for the
mounting.
Make sure power is not supplied to
the appliance while installation or
maintenance work is performed.
Disconnect the power supply to the
work area by unplugging the unit,
tripping the circuit breaker or
removing the fuse. The coffee
system must be installed into
cabinetry before being used.
^ Center the unit and turn the screws a
little bit in and then out again.
^ Take the unit out of the niche and drill
four holes at the screw markings
(1/16" [2 mm], diameter 3/16"
[4.5 mm]).
^ Connect the appliance to a cold
water supply.
^ Plug the appliance into the electrical
outlet.
^ Push the appliance into the niche.
^ Unscrew the height adjustable feet
on the underside of the machine
about 1/16" (2 mm).
^ Push the appliance all the way back
into the cabinet and center it. If
necessary level the unit with the four
height adjustable feet.
^ Open the door and partially tighten
the screws.
The feet can be turned out up to 3/8"
(10 mm).
^ Carefully turn the lower screws, a, to
center the machine.
^ To secure the appliance in the
cabinet, tighten the upper screws, b,
by hand. Do not use an electric
screwdriver.
59
Installation
Adjusting the door hinges
The door hinges can be adjusted if the
door cannot be opened easily.
^ To adjust the door sideways, a, turn
screw a.
^ To adjust the door to the front or
back, b, turn screw b.
60
Alteration rights reserved / 0607
CVA 4070
M.-Nr. 06 911 520 / 02
en - USA / CDN
For the most updated manual see the MIele Website.
|