music hall
dac15.2
INSTRUCTION MANUAL
digital to analog converter
music hall
6. Climate
The unit has been designed for use in moderate climates. Do not attempt to use
below 41 degrees Fahrenheit (5 degrees Celsius) or above 95 degrees Fahrenheit
(35 degrees Celsius).
7. Rack and Stands
Place the unit on a fixed, level surface strong enough to support its weight. Do
not place it on a moveable cart that could tip over. We recommend only using
stands approved for use with audio equipment.
8. Cleaning
Unplug the unit from the mains supply before cleaning. The case should normally
require only a wipe with a soft lint-free cloth.
9. Power Sources
Only connect the unit to a power supply of the type and voltage described in the
operating instructions or specified on the rear panel of the unit.
10. Power cord protection
Connect the unit to the power outlet only with the cord supplied. Do not modify
the supplied cable in any way. Do not attempt to defeat grounding and/or
polarization provisions. Do not use extension cords. Do not route the power cord
where it will be crushed, pinched, bent at severe angles, exposed to heat, or
damaged in any way.
11. Non-use periods
If the unit is to be left unused for a long period of time, the power cord should be
unplugged from the wall outlet.
12. Damage Requiring Service
Stop using the unit immediately and have it inspected by an authorized music hall
service center whenever:
1. The power supply cord or plug has been damaged.
2. Liquid has been spilled into the unit.
3. The unit has been exposed to rain.
4. The unit does not operate properly.
5. The unit has been dropped or damaged.
6. Smoke or any unusual smell is detected from the unit.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
2
Getting Started
Thank you for purchasing the music hall dac15.2. The dac15.2 is a solid-state
digital- to-analog converter (DAC) designed for the music lover.
We chose a
select group of technologically advanced components to create this sophisticated
digital-to-analog converter. The dac15.2 can accept any coax (s/pdif), USB, or
optical (toslink) digital input from one of music hall's compact disc players, a
CD/DVD transport, iPod transport, computer, media server, Sonos, Squeezebox,
DVD in stereo, and will output two channel stereo analog. When used with your
computer or in a top-end audio system, your music hall digital-to-analog converter
will provide years of listening enjoyment.
The dac15.2 features the latest Texas Instruments (formerly Burr-Brown) PCM
1796 24bit, 192kHz, advanced segment, stereo audio digital-to-analog converter.
This processor features 123dB dynamic range, an 8 x oversampling digital filter,
and just 0.0005% THD.
A Few Precautions
Please read this manual carefully. In addition to installation and operating
instructions, it provides valuable information that will help you get optimum
performance from your system. Please contact your authorized music hall dealer
for answers to your questions. In addition, all of us at music hall welcome your
questions and comments. Save the shipping carton and all enclosed packing
material for future use. Shipping or moving the unit in anything other than the
original packing material may result in severe damage that is not covered by the
warranty. Be sure to keep the original sales receipt. It is your best record of the
date of purchase, which you will need in the event warranty service is required.
Placement
Use common sense when placing the dac15.2. Always place it on a firm, level
surface. Make sure that the shelf or cabinet can support the weight. Ensure that
there is adequate ventilation. Avoid placing the dac15.2 where it may be subject
to excessive heat, such as near a heat register. Do not place anything on top of it.
For best performance, avoid placing the dac15.2 where it may be subject to
vibration, such as near a speaker.
Audio Out
To avoid damage to the dac15.2, make sure it is NOT plugged into an AC outlet
while connecting up or disconnecting the audio outputs. The dac15.2 has one set
of fixed audio outputs on the back. Connect the ANALOG OUT connectors to the
appropriate audio inputs on your integrated amplifier, preamplifier, or receiver.
3
R
ANALOG OUT
OPTICAL
COAXIAL
L
OUT
IN
USB
12V DC
R
designed and developed in the USA
Connecting to the Mains - Plugging In
Check that the Power Switch on the front of the dac15.2 is in the off
position. Look at the voltage selector slider on the back of the unit and
confirm that it is set for the correct voltage: (~115V USA/~230V Europe).
Connect the low voltage plug from the power supply to 12V DC
socket on the dac15.2 before connecting to the mains.
Digital In - Connecting Source Components to the dac15.2
The dac15.2 has 3 digital inputs: COAXIAL IN (s/pdif), OPTICAL (toslink),
and USB.
Connect your source components to the appropriate inputs on the back of
the dac15.2. You can connect one or all three inputs at the same time.
Choose between the inputs using the input selector on the front panel.
Special note: When connecting the dac15.2 via USB to your computer:
the dac15.2 and your computer should both be powered up. Quit any
open media player programs (iTunes, Windows Media, Real Media,
etc) on your computer prior to connecting the dac15.2.
Connect the USB cable from your computer to the dac15.2. Your computer
will recognize the dac15.2 and install the necessary drivers.
You will probably find that setting your media player and computer volume
to max will sound best.
Apple computers and some PC's may not automatically recognize the
dac15.2. In this case; with your computer and the dac15.2 powered up;
connect the USB cable. Go to System Preferences (Control Panel)
Output choose the USB Audio DAC for output. Close System Preferences.
Launch iTunes.
Sound
4
Digital Out COAXIAL OUT
S/PDIF output for use with other digital components. This output converts the
USB and OPTICAL (toslink) input signal to an S/PDIF output.
Using the dac15.2
power - on/off
Turn on the dac15.2. If no digital input is active the locked light will not light.
input
Use the input switch to select desired input. Enjoy.
power
locked
usb
coaxial
optical
on
off
dac15.2 digital to analog converteerr
Troubleshooting
If no sound comes out of the system with the dac15.2 connected, there are
several areas to check. Either you are not getting an audio signal to your
preamplifier, or you don't have a good digital source feeding the dac15.2.
First, check to make sure your preamplifier, integrated amp, or receiver is
switched to the input that the dac15.2 is connected to. Test the connection and
the cables to make sure. Keeping the input selected and using the same cable,
connect this input to a known good source like a tuner or the analog output of a
CD player. If that works, then it is most likely not a connection problem between
the dac15.2 and the preamp, integrated amp, or receiver.
The next step is to check and see if the digital input is properly connected. Look
on the front panel of the dac15.2 to see if the locked light is illuminated. If it is
not, this is most likely the problem. Switch the input selector to another input to
see if one locks. If one does not lock, you either have a bad digital cable or you
aren't getting a good digital signal. Try replacing the digital cable on the input
you've selected. For instance, if you are using a coax connection try replacing the
coax cable with another coax cable. If this doesn't work, try selecting a different
input (optical for instance) and try using the CD player's optical output with an
optical cable instead.
5
If you are using a USB connection, it is necessary for the computer to recognize
the dac15.2 as a connected device. Check in the computer's control panel under
USB devices and see if the dac15.2 is selected. If not, with both the dac15.2 and
your computer powered up, remove the USB cable from the computer and then
re-insert it. Watch the computer monitor for an indication it has found the
hardware. Apple computers may not automatically recognize the dac15.2. Apple
users check your System Preferences as suggested above.
Technical Specifications
THD+N: <0.0012% (20Hz 20kHz)
Output level: RCA 2.1V
COAX 0.5Vp-p (@75 OHM)
Frequency response: DC-20KHz +/-0.5dB
SNR: >110dB
Power dissipation: <10W
Dynamic range: > 115dB (24 bit)
> 96dB (16bit)
Crosstalk: <-105dB
Operating temperature: 0 ~ 40
USB input accepts 24bit/96kHz signals
All other inputs accept signals up to 24bit/192kHz
Power supply: AC100-240V 50/60Hz
Ti PCM1796 24bit/192kHz DAC
Physical
Dimensions: W x D x H (4.2 x 6.0 x 2.0 in.) (107 x 152 x 52)
Weight: 3 lbs. Pkg.
Supplied Accessories: external power transformer
USA - This product complies with FCC requirements.
6
Guarantee
This entitles you to have the music hall dac15.2 repaired or replaced, at our
discretion, free of charge for one year after purchase, at any authorized music hall
dealer, provided the unit was purchased from an authorized dealer. Your original
sales receipt is used as proof of purchase date. Music hall can take no
responsibility for defects arising from accident, misuse, abuse, wear and tear,
neglect or through unauthorized repair and or adjustment. Neither can music hall
accept responsibility for damage or loss occurring during transit to or from the
person claiming under the guarantee.
Warranty
Your music hall dac15.2 warranty covers parts and labor costs for one year from
the purchase date. After one year, you must pay for both parts and labor costs.
The warranty does not cover transportation costs at any time.
Claims under guarantee
The unit should be packed in the original packing and returned to the dealer from
whom it was purchased, or to an authorized music hall service center. It should
be sent by a reputable carrier, carriage prepaid. Do not send the unit via USPS
(United States Postal Service). No responsibility can be accepted for the unit
while in transit to the dealer, customer, or authorized service agent, therefore,
customers are advised to insure the unit against loss, damage, or theft while in
transit.
FOR FURTHER INFORMATION CONTACT:
Music Hall
108 Station Road
Great Neck, NY 11023
Tel: 516-487-3663
Fax: 516-773-3891
|