V-PSUII Power Supply Unit
This product has been tested to ensure that
its operation is not adversely affected by
Thank you for purchasing the V-PSUII power normal background levels of Radio
supply unit. We sincerely hope that it will Frequency Interference (R.F.I.), and that it
bring you many years of outstanding does not itself generate excessive amounts
Instructions
Introduction
listening pleasure.
of interference. However, if
a
problem
persists, please contact your Musical Fidelity
agent.
Installation Precautions
Your new V-PSUII is designed and built to Never open the case of the
V-PSUII
provide trouble-free performance, but as with yourself, as this will invalidate the guarantee.
all electronic devices, it is necessary to Place all connecting cables where they are
observe a few precautions:
not likely to be walked on or trapped by
Do not use the V-PSUII near water. The unit items placed on them.
must not be exposed to dripping or splashing The V-PSUII will operate in accordance with
and no objects filled with liquids, such as its specifications within the following
vases, must be placed on the unit.
environmental range:
Keep the V-PSUII away from heat such as
radiators. No naked flame sources, such as Temperature 5 to 45 degrees Celsius
lighted candles, should be placed on the Humidity 10 to 90% non condensing
unit.
There are no user adjustments inside.
Please refer all service work to an
authorised Musical Fidelity agent.
Connections
Front and back connections
All connections must be made before the mains adaptor is
plugged in, and before any amplifier connected is switched
on. Always switch off the V-PSUII (and connected amplifiers
etc) before connecting/disconnecting power, or changing
leads.
Power output sockets
and indicator LEDs
Power Inputs
Using figure-8 moulded mains lead (supplied), connect the
V-PSUII to a mains socket.
Power Outputs
Using 1.3mm DC plug to plug lead(s) (supplied), connect
the V-PSUII 12VDC OUTPUTS to the V-series units as
required.
Use
Connect up the V-series components audio inputs and
outputs as required.
Switch on the V-PSUII using the rocker switch next to the
mains input socket.
The three individual output LEDs should light indicating
presence of power at the respective output.
Switch on attached components (amplifiers etc).
Turn the volume on amplifier to normal listening levels, sit
back and enjoy the music.
These products have been designed so that it may be left
on indefinitely, but please note that the V-PSUII may
become warm to the touch - this is normal.
Power switch
Power input socket
Note: The V-PSUII can also be used to power older V-series
components.
|