NEC Computer Hardware ES Series User Manual

409-00072-000 6/7/00 11:30 AM Page 1  
®
PowerMate ES Series System Board Configuration  
Jumper Settings  
JP2  
JP2  
USB  
Keyboard  
Wakeup  
Factory setting.  
Disables system  
wakeup by USB  
keyboard.  
Enables system  
wakeup by USB  
keyboard.  
3
2
1
3
2
1
Note: See your PowerMate ES Series User’s Guide  
for detailed option installation information.  
JP1  
Keyboard  
at  
Power On  
Factory setting.  
Disables keyboard at power on.  
Memory Upgrade  
Maximum memory supported: 512 MB;  
minimum memory required: 32 MB.  
1
1
2
3
3
JP1  
Enables keyboard  
at power on.  
Memory type and size can vary between sockets.  
2
System supports 168-pin, 100-MHz non-ECC SDRAM modules  
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.  
Use NEC memory upgrade kits for the best compatibility with your  
system. For memory compatibility information, call Technical Support.  
JP3  
JP3  
Save to  
RAM  
Factory setting.  
Enables Suspend  
mode Save to RAM  
(STR) function.  
Disables Save  
to RAM function.  
Single- or double-sided DIMMS are supported.  
No jumper setting required.  
JP13  
2
JP13  
USB Port  
Selection  
Factory setting.  
Disables front  
USB port and  
enables rear  
USB port.  
3
6
1
3
2
1
Enables front  
USB port and  
rear USB port.  
Processor Upgrade  
See your user’s guide for detailed processor upgrade information.  
5
4
6
5
4
JP2  
Processor Socket 370  
JP19  
PCI Slots  
Jumper  
CMOS  
Clear  
Factory setting. Maintains system board  
configuration in CMOS RAM with onboard  
battery.  
1
2
3
JP1  
Jumper  
JP19  
Clears CMOS while system power is off.  
Return jumper to pins 2 and 3 before  
powering system on.  
1
2
3
Caution: To prevent damage to the system board,  
avoid clearing CMOS while power is on.  
JP15  
System  
Memory  
Upgrade  
Sockets  
BIOS  
Recovery  
Factory setting. Sets the system for  
normal operation. The BIOS uses current  
configuration information and passwords  
at power on.  
1
2
3
To enable BIOS recovery for a corrupted  
system, remove the jumper. Wait 10 seconds.  
Replace the jumper on pins 1 and 2.  
JP15  
JP13  
Jumper  
Primary  
IDE Connector  
JP3  
Restores Safe BIOS settings as the  
default BIOS settings and loads the  
BIOS Setup at power on.  
Jumper  
1
2
3
Secondary  
IDE Connector  
JP15  
Jumper  
JP19  
Jumper  
Technical Support: 800-632-4525  
409-00072-000  
 

Miele Washer W 4446 WPS User Manual
Navigon PDAs Smartphones MN4 User Manual
NEC Answering Machine 408 VM User Manual
NEC Computer Monitor PA231W User Manual
NETGEAR Network Router FVS328 User Manual
NETGEAR Network Router WNHDE111 5GHz User Manual
Nortel Networks Telephone 4027 User Manual
Oki Printer 8z User Manual
Oreck Vacuum Cleaner PR8000 User Manual
Panasonic Camera Accessories AF100 User Manual