WNCE2001_IG.fm Page 1 Friday, April 9, 2010 3:14 PM
WPS (WiFi Protected Setup) is a simple and secured way to connect a device to an existing network.
If you have a NETGEAR router, this feature is called Push ‘N’ Connect. Look for the or symbols on the router to make sure
the NETGEAR router supports WPS. For non-NETGEAR routers, please refer to the user manual to determine if the router supports WPS.
Once you know whether your router supports WPS, choose the appropriate installation method below.
What is WPS?
Universal WiFi Internet Adapter (WNCE2001)
Package Contents
Installation with WPS
Installation without WPS
Step 1: Please disconnect any wireless connection to the router
and/or remove the Ethernet cable currently connected to
the computer. You may restore the connection after the
WNCE2001 installation is complete.
Power
adapter
Step 1: Connect the WNCE2001
to your TV, XBox, or Blu-ray
player using the Ethernet
cable (included) and one
of the power connection
Step 2: Connect the WNCE2001 to your computer, using the
Ethernet cable (included) and one of the power connection
options. For more information on power-up methods,
see “Power Connection Options” on the reverse side.
options. For more information
on power-up methods,
WNCE2001
see “Power Connection
Options” on the reverse side.
Step 2: Push the WPS button on the
USB power
Ethernet cable
cable
WNCE2001. The WLAN LED
will blink amber and green,
showing that the WPS is
running.
Top and Back Views
Step 3: Open your Internet browser and it will automatically take you
to the setup page. Follow the instructions on the setup page,
then return to this guide and continue to Step 4.
Step 3: Push the WPS button on your router. The WLAN LED
on the WNCE2001 will stay green for
5 seconds when the wireless connection has been
established.
Step 4: Disconnect the Ethernet and USB cables from your computer.
Step 5: Connect the WNCE2001 to your TV, Box, or Blu-ray player.
If your device doesn’t have a USB port, see
WPS
button
Step 4: Congratulations! Your installation is complete.
“Power Connection Options” on the reverse side.
Reset
button
Power
WPS
button
Power
LED
Ethernet
Port
WLAN
LED
LAN
LED
Step 6: Congratulations! Your installation is complete.
|