SERVICE FOR YOUR NADY AUDIO PRODUCT
(U.S.) Should your NADY AUDIO product require service, please contact the Nady Service
Department via telephone at (510) 652-2411, or e-mail at [email protected].
OWNER’S MANUAL
(International) For service, please contact the NADY AUDIO distributor in your country
through the dealer from whom you purchased this product.
DO NOT ATTEMPT TO SERVICE THIS UNIT
YOURSELF AS IT CAN BE DANGEROUS AND
WILL ALSO VOID THE WARRANTY.
ADI-2
NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608
2 Channel Active Direct Inject Box
Controls and Connections
2
7
1
6
4
5
3
4
5
(1) ON/OFF SWITCH
When set to ON, this enables the 9V battery power for the unit. If the device connected
to the ADI-2 XLR output has 25V-48V phantom power enabled, the ADI-2 can be used
without draining the 9V battery. Disabling the ON/OFF button will save battery power
when using phantom power. Always remember to turn off the ADI-2 ON/OFF switch when
not in use to preserve your battery.
(4) 1/4" INPUTS
Unbalanced 1/4" input jack for inputting a line level, instrument level, or speaker level
signal.
(5) 1/4" LINK OUTPUTS
Unbalanced 1/4" output jack which is in parallel with the input jack. This allows the ADI-2
to be used as a Y-splitter by sending the input signal to another device via the 1/4" output
as well as sending it from the balanced XLR output.
CAUTION: Always turn on the ADI-2 before turning up the volume on devices connected
to the ADI-2 outputs to avoid damaging your equipment or speakers.
(2) GROUND LIFT SWITCH
(6) XLR OUTPUTS
When set to LIFT, this disconnects the ground connection between the 1/4" input and XLR
Balanced XLR output jack [Pin 1 = Ground, Pin 2 = Hot(+), Pin 3 = Cold(-)]
output to eliminate hum caused by ground loops.
(7) BATTERY COMPARTMENT
(3) SPEAKER/GUITAR BUTTON
Remove screw and panel to install 9V battery.
When pushed in, this enables a 35dB pad, allowing the input to receive high level signals
from speaker or amplifier outputs.
3
4
|