A
Return
to Menu
Wall mount with a telephone stand
1
Cord connections
1
B
J
J
Press here to remove the stand.
C
H
I
T7316E Telephone User Card
D
key hole slots
Use the key hole slots on the stand
to mark the location for the screws.
Tighten screws for a secure fit.
Slide feature card plate down.
K
K
E
2
Desk mount option
Route line cord through the stand.
2
L
F
G
Headset option
Connect cord to
headset.
Mount the stand as shown.
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
Connect cord
to handset.
3
1-800-4 NORTEL
M
N
© 2003 Nortel Networks
P0603479 02
Mount the telephone
onto the screws and
slide it down.
3
Printed in Canada
Connect line cord
to wall jack.
Connect line cord to
wall jack.
Your T7316E telephone
More on your T7316E telephone
A
Telephone light
G
Audio cluster buttons
Flashes for incoming calls.
Wall mount without a telephone stand
1
Telephone setup
© Mute button
Turns the microphone off or on when you are on a call.
Handsfree button
For more information on using the handsfree feature,
refer to the “Handsfree calls” section in this card.
¬ Headset button
Lights up when Message Waiting Indication (MWI) is
supported by system software. Contact your system
administrator for more information.
Display contrast level
Press here to remove the stand.
Adjust the contrast of your display.
1. Press ≤•‡.
B
C
Adjustable tilt display
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
2. Press UP or DOWN to view the levels.
3. Press OK to select a level.
Shows the time and date, call and feature information.
Turns the headset mode on.
Display buttons
H
I
≤ Feature button
The label for display buttons appear in capital letters
on the bottom of the display. Display buttons change
with each feature you use.
Language choice
Starts or ends a feature.
≤•fi‚⁄
≥ Hold button
2
Select Primary Language for the telephone display.
≤•fi‚¤
Places calls on hold.
Contrast level 2
Feature message
Select Alternate Language for the telephone display.
≤•fi‚‹
J
K
L
Memory buttons
DOWN UP OK
Display button label
Select Alternate Language 2 for the telephone display.
≤•fi‚›
Memory and line buttons
Display button
Indicators
D
® Release button
Select Alternate Language 3 for the telephone display.
Appear next to active line and memory buttons.
Ends an active call or feature.
Ring type
M
N
Number card
E
F
Dial pad
Select a different ring for your telephone.
1. Press ≤•fl.
Connect line cord to
wall jack.
Write your extension number on this card.
√ Volume control
Adjusts the handset, handsfree, headset and ringer
volume.
2. Press ⁄, ¤, ‹, › or NEXT to hear the different
ring types.
3. Press OK to store the ring type.
Feature card plate
Place the telephone onto
the wall mount plate and
slide it down.
Storage compartment for your feature card.
|