Stereo Headset
Amplifier With Mike
Return & Radar
Beep Capability
Part #MA-967
Installation
Instructions
3) Using one of J&M's Plug and Play radar harnesses, connect your radar
detector to the proper plugs from the MA-967 amplifier. (See Diagram)
Note: It is not necessary to use the radar detector cable option for
proper operation of this audio system.
4) Route the headset lead from the MA-967 amplifier to the left handle-
bar or to a convenient location on your motorcycle, to allow convenient
connection of your helmet headset.
5) Connect the power wire (with fuse holder) to a switchable power
source or accessory terminal, so that the amplifier is turned off when the
ignition is turned off. Connect the black wire to a good frame ground (not
to the battery negative).
Operation - Cell Phone
This integration terminal can utilize the available Bluetooth cell phone
link built into many of today’s Stereo/NAV units, for hands free cell
phone operation through a single helmet headset. (See operation manual
for your particullar Stereo/NAV unit.)
Operation - Radar/Audio
The beeps/braps from the radar detector will be heard in one speaker of
the helmet headset if so installed.
The volume levels of each of your Stereo/NAV unit’s audio functions
(stereo music/GPS route commands, etc.) can be adjusted individually
using the controls built into your particular Stereo/NAV unit.
Thank you for the confidence you have shown by purchasing one of J&M’s
innovative products. If you have any questions during installation, or require further
assistance, you may call us at 1-800-358-0881 from 8:00 a.m. to 5:00 p.m.
Mountain Standard Time, Monday through Friday.
Tucson, Arizona, U.S.A.
Tel: (800) 358-0881
E-mail: [email protected]
|